All Issue

2025 Vol.57, Issue 6 Preview Page

Original Paper

Effect of Lignin Recovery Conditions from Hardwood Kraft Black Liquor on Lignin Characteristics
Sa Rang Choi1
,
Eon Jin Park2
,
Jung Myoung Lee3†
1Institute of Agricultural Science and Technology, Kyungpook National University, Researcher
2Department of Wood and Paper Science, Kyungpook National University, Student
3Department of Wood and Paper Science, Kyungpook National University, Professor
†Corresponding Author: E-mail: jmylee@knu.ac.kr (Address: Department of Wood and Paper Science, Kyungpook National University, Daegu, 41566, Republic of Korea)
30 December 2025. pp. 85-83
PDF XML Citation
Abstract

Black liquor, generated during the pulp and paper manufacturing process, is produced in millions of tons annually; however, most of it is burned as boiler fuel for energy recovery. Recently, efforts have increasingly been made to utilize this low-value byproduct as a source of functional industrial materials by converting the lignin it contains into high-performance biopolymers. In this study, lignin was recovered from hardwood kraft black liquor, and the effects of acid addition sequence, precipitation pH, and black liquor dilution ratio on recovery efficiency and lignin characteristics were systematically analyzed. The highest lignin recovery was achieved under single acidification at pH 3, while the recovery method based on adding black liquor to acid exhibited slightly higher recovery efficiency than that based on adding acid to black liquor. Molecular weight analysis revealed that under strongly acidic conditions, Mw decreased and a lower polydispersity index (PDI) was achieved, indicating a more uniform molecular weight distribution. Additionally, experiments on dilution concentration showed that lignin with the highest purity (up to 94.7%) and the most homogeneous molecular structure was obtained at 20% dilution. These results demonstrate that lignin fractionation and structural control can be achieved through precise adjustment of acidification and dilution conditions, providing a strong foundation for optimizing process strategies in the development of lignin-based functional polymer materials.

Keywords
Kraft lignin
lignin recovery
acid precipitation
black liquor
high-purity lignin
References
1

Morya, R., Kumar, M., Tyagi, I., Pandey, A. K., Park, J., Raj, T., Sirohi, R., Kumar, V., & Kim, S. H. (2022). Recent advances in black liquor valorization. Bioresource Technology, 350, 126916.

10.1016/j.biortech.2022.126916
2

Im, H. J., Choi, S. R., & Lee, J. M. (2025). Evaluation of filter press performance for extracting lignin from acid-based black liquor. Journal of Korea TAPPI, 57(1), 50-57.

10.7584/JKTAPPI.2025.2.57.1.50
3

Im, H. J., Jang, J. W., Yang, S., Lee, S. H., Choi, S. R., & Lee, J. M. (2024). Evaluation of filter cloths properties for extracting lignin from black liquor by filter press. Journal of Korea TAPPI, 56(6), 59-65.

10.7584/JKTAPPI.2024.12.56.6.59
4

Cline, S. P., & Smith, P. M. (2017). Opportunities for lignin valorization: An exploratory process. Energy, Sustainability and Society, 7(1), 26.

10.1186/s13705-017-0129-9
5

Strassberger, Z., Tanase, S., & Rothenberg, G. (2014). The pros and cons of lignin valorisation in an integrated biorefinery. RSC Advances, 4(48), 25310-25318.

10.1039/C4RA04747H
6

Argyropoulos, D. D., Crestini, C., Dahlstrand, C., Furusjö, E., Gioia, C., Jedvert, K., & Wimby, M. (2023). Kraft lignin: A valuable, sustainable resource—Opportunities and challenges. ChemSusChem, 16(23), e202300492.

10.1002/cssc.202300492
7

Hubbe, M. A., Alén, R., Paleologou, M., Kannangara, M., & Kihlman, J. (2019). Lignin recovery from spent alkaline pulping liquors using acidification, membrane separation, and related processing steps: A review. BioResources, 14(1), 2300-2351.

10.15376/biores.14.1.Hubbe
8

Sun, R., Tomkinson, J., & Bolton, J. (1999). Effects of precipitation pH on the physico-chemical properties of the lignins isolated from the black liquor of oil palm empty fruit bunch fibre pulping. Polymer Degradation and Stability, 63(2), 195-200.

10.1016/S0141-3910(98)00091-3
9

Sewring, T., Durruty, J., Schneider, L., Schneider, H., Mattsson, T., & Theliander, H. (2019). Acid precipitation of kraft lignin from aqueous solutions: The influence of pH, temperature, and xylan. Journal of Wood Chemistry and Technology, 39(1), 1-13.

10.1080/02773813.2018.1488870
10

Watumlawar, E. C., & Park, B. D. (2023). Effects of precipitation pH of black liquor on characteristics of precipitated and acetone-fractionated kraft lignin. Journal of the Korean Wood Science and Technology, 51(1), 38-48.

10.5658/WOOD.2023.51.1.38
11

Ryu, J. A., Choi, H. S., & Lee, J. M. (2021). Characteristics of organosolv lignin precipitated via pH control. Journal of Korea TAPPI, 53(1), 22-29.

10.7584/JKTAPPI.2021.02.53.1.22
12

Velez, J., & Thies, M. C. (2013). Solvated liquid-lignin fractions from a kraft black liquor. Bioresource Technology, 148, 586-590.

10.1016/j.biortech.2013.08.097
13

Yan, L., Huertas-Alonso, A. J., Liu, H., Dai, L., Si, C., & Sipponen, M. H. (2025). Lignin polymerization: Towards high-performance materials. Chemical Society Reviews, 54, 6634-6651.

10.1039/D4CS01044B
14

Pylypchuk, I., & Sipponen, M. H. (2022). Organic solvent-free production of colloidally stable spherical lignin nanoparticles at high mass concentrations. Green Chemistry, 24(22), 8705-8715.

10.1039/D2GC02316D
15

Wörner, M., Werner, L., Hornung, U., Islongo Canabarro, N., Baudouin, D., & Dahmen, N. (2024). The impact of sulfur-containing inorganic compounds during the depolymerization of lignin by hydrothermal liquefaction of black liquor. Energy & Fuels, 38(7), 6036-6047.

10.1021/acs.energyfuels.3c0473738595992PMC11000222
16

Olgun, Ç., & Ateş, S. (2023). Characterization and comparison of some kraft lignins isolated from different sources. Forests, 14(5), 882.

10.3390/f14050882
17

da Silva, P. M., & Pasa, V. M. D. (2023). Upgrading of kraft lignin with phosphoric acid purification: A promising route for the synthesis of renewable epoxy resins. Industrial Crops and Products, 204, 117202.

10.1016/j.indcrop.2023.117202
18

De Santi, A., Monti, S., Barcaro, G., Zhang, Z., Barta, K., & Deuss, P. J. (2021). New mechanistic insights into the lignin β-O-4 linkage acidolysis with ethylene glycol stabilization aided by multilevel computational chemistry. ACS Sustainable Chemistry & Engineering, 9(5), 2388-2399.

10.1021/acssuschemeng.0c0890133585085PMC7874265
19

Norgren, M., Edlund, H., Wågberg, L., Lindström, B., & Annergren, G. (2001). Aggregation of kraft lignin derivatives under conditions relevant to the process. Part I: Phase behaviour. Colloids and Surfaces A: Physicochemical and Engineering Aspects, 194(1-3), 85-96.

10.1016/S0927-7757(01)00753-1
20

Zhu, W., & Theliander, H. (2015). Precipitation of lignin from softwood black liquor: An investigation of the equilibrium and molecular properties of lignin. BioResources, 10(1), 1696-1714.

10.15376/biores.10.1.1696-1714
Information
  • Publisher :Korea Technical Association of The Pulp and Paper Industry
  • Publisher(Ko) :한국펄프종이공학회
  • Journal Title :Journal of Korea TAPPI
  • Journal Title(Ko) :펄프종이기술
  • Volume : 57
  • No :6
  • Pages :85-83
  • Received Date : 2025-11-03
  • Revised Date : 2025-11-19
  • Accepted Date : 2025-11-20
  • DOI :https://doi.org/10.7584/JKTAPPI.2025.12.57.6.85
Journal Informaiton Journal of Korea TAPPI Journal of Korea TAPPI
Online Submission
  • scopus
  • NRF
  • KOFST
  • crossref crossmark
  • crossref cited-by
  • crosscheck
  • orcid
Journal Informaiton Journal Informaiton - close