All Issue

2024 Vol.56, Issue 5 Preview Page

Research Article

Improvement of Carbon Black Retention in Wet-end Part for Manufacturing Fruit Bag Base Paper with High Light Blocking Property

높은 광차단성 과일봉지 원지 생산을 위한 카본블랙의 보류 향상을 위한 연구

Sung Gyu Park1
,
Ji Hyun Tak1
,
Min Seo Kim2
,
Ji Soo Lee2
,
Ji Young Lee3†
,
Jun Sik Ha4
박 성규1
,
탁 지현1
,
김 민서2
,
이 지수2
,
이 지영3†
,
하 준식4
1Department of Forest Products, Gyeongsang National University, Jinju, 52828, Republic of Korea
2Department of Environmental Materials Science, Gyeongsang National University, Jinju, 52828, Republic of Korea
3Department of Environmental Materials Science/IALS, Gyeongsang National University, Jinju, 52828, Republic of Korea
4Namgang Paper Co. Ltd., Jinju, 52781, Republic of Korea
1경상국립대학교 임산공학과, 대학원생
2경상국립대학교 환경재료과학과, 대학생
3경상국립대학교 환경재료과학과/농업생명과학연구원, 교수
4남강제지(주), 대표이사
†Corresponding author: E-Mail: paperyjy@gnu.ac.kr (Address: Department of Environmental Materials Science/IALS, Gyeongsang National University, Jinju, 52828, Republic of Korea)
30 October 2024. pp. 49-57
PDF XML Citation
Abstract

In this study, we evaluated carbon black's adsorption properties and high fixation conditions for improving the lightproof base paper for fruit bags. Carbon black is a black pigment that has been used in fruit bags to improve lightproof. Particle size and zeta potential of carbon black were measured. The fiber properties of old newsprint, feed bag, and kraft paper used to manufacture hand sheets were analyzed. Hand sheets were prepared by changing the carbon black dosage and the stirring time after addition. The carbon black had a negative charge and a smaller particle size than other fillers used in the papermaking process. However, through SEM images, we observed that carbon black particles are agglomerating with each other. The fiber length and fiber width of kraft paper were greater than those of other pulps, but the fines content of kraft pulp was less than that of feed bag. Carbon black dosage and stirring time were set to 8, 12, 16, and 20% and 2, 10, and 30 minutes, respectively. As the carbon black dosage and stirring time increased, the L* value of the hand sheets decreased. However, it was confirmed that the L value hardly changed when the carbon black dosage and stirring time increased beyond a certain level. As a result of comparing the L* values for each type of pulp, the L* value of the feed bag decreased the most. These results suggested that fiber properties affect carbon black adsorption. Therefore, if the carbon black dosage and stirring time are increased to a certain level and the fiber properties are taken into consideration, it is expected that the lightproof of fruit bags can be improved.

Keywords
Carbon black
fruit bag
adsorption
lightproof
L* value
old newsprint
feed bag
kraft paper
References
1

Frank, D. L., Evaluation of fruit bagging as a pest management option for direct pests of apple, Insects 9(4):1-12 (2018).

10.3390/insects9040178
2

Hofman, P. J., Smith, L. G., Joyce, D. C., Johson, G. I., and Meiburg, G. F., Bagging of mango (Mangifera ra indica cv. 'Keitt') fruit influence fruit quality and mineral composition, Postharvest Biology and Technology 12(1):83-91 (1997).

10.1016/S0925-5214(97)00039-2
3

Leite, G. L. D., Fialho, A., Zanuncio, J. C., and Junior, R. R., Bagging tomato fruits: A viable economical method of preventing diseases and insect damage in organic production, The Florida Entomologist 97(1):50-60 (2014).

10.1653/024.097.0106
4

Yang, H. G., Gu, F. W., Wang, B. K., Shi, L., and Hu, Z. C., Production, use and recycling of fruit cultivating bags in china, Sustainability 14(21):1-18 (2022).

10.3390/su142114144
5

Buthelezi, N. M. D., Mafeo, T. P., and Mathaba, N., Preharvest bagging as an alternative technique for enhancing fruit quality: A review, HortTechnology 31:1-10 (2021).

10.21273/HORTTECH04658-20
6

Kasso, M. and Bekele, A., Post-harvest loss and quality deterioration of horticultural crops in Dire DaWa Region, Ethiopia, Journal of the Saudi Society of Agriculture Sciences 17(1):88-96 (2018).

10.1016/j.jssas.2016.01.005
7

Ali, M. M., Anwar, R., Yousef, A. F., Li, B., Luvisi, A., Bellis, L. D., Aprile, A., and Chen, F., Influence of Bagging on the development and quality of fruits, Plants 10(2):1-16 (2021).

10.3390/plants10020358
8

Sharma, R. R., Reddy, S. V. R., and Jhalegar, M. J., Pre-harvest fruit bagging: A useful approach for plant protection and improved post-harvest fruit quality-A review, The Journal of Horticultural Science and Biotechnology 89(2):101-113 (2014).

10.1080/14620316.2014.11513055
9

Das, S. C., Datta, M., Ray, P., Singh, S. K., Jena, R. K., Das, B., and Ray, S. K., Mango(Mangifera indica) Cultivation in north-eastern region of india, Advanced Agriculture Research & Technology Journal 3(1):54-66 (2019).

10

Yadav, A. S. and Pandey, D. C., Geographical perspective of mango production in india, Imperial Journal of Interdisciplinary Research 2(4):257-265 (2016).

11

Jo, H. M., Lee, J. Y., Kim S. H., and Lee, Y. H., Strength Improvement of the coloring paper for fruit bag by using non-woody bamboo kraft pulp, Journal of Korea TAPPI 52(6):132-139 (2020).

10.7584/JKTAPPI.2020.12.52.6.132
12

Hauptman, N., Gunde, M. K., Kunaver, M., and Bešter-Rogač, M., Influence of dispersing additives on the conductivity of carbon black pigment dispersion, Journal of Coatings Technology and Research 8(5):553-561 (2011).

10.1007/s11998-011-9330-5
13

Donnet, J. B., Bansal, R. C., and Wang, M. J., Carbon black Science and Technology, Marcel Dekker, New York (1993).

14

Balberg, I., A comprehensive picture of the electrical phenomena in carbon black-polymer composites, Carbon 40(2):139-143 (2002).

10.1016/S0008-6223(01)00164-6
15

El-Tantawy, F., Kamada, K., and Ohnabe, H., Electrical properties and stability of epoxy reinforced carbon black composites, Materials Letters 57(1):242-251 (2002).

10.1016/S0167-577X(02)00774-7
16

Salmi, A., Benfarhi, S., Donnet, J. B., and Decker, C., Synthesis of carbon-polyacrylate nanocomposite materials by crosslinking polymerization, European Polymer Journal 42(9):1966-1974 (2006).

10.1016/j.eurpolymj.2006.05.027
17

Zhang, W., Dehghani-Sanji, A. A., and Blackburn, R. S., Carbon based conductive polymer composites, Journal of materials Science 42:3408-3418 (2007).

10.1007/s10853-007-1688-5
18

Hauptman, N., Žveglič, M., Maček, M., and Gunde, M. K., Carbon based conductive photoresist, Journal of Materials Science 44:4625-4632 (2009).

10.1007/s10853-009-3706-2
19

Fujitani, T., Stability of pigment and resin dispersions in waterborne paint, Progress in Organic Coatings 29(1-4):97-105 (1996).

10.1016/S0300-9440(96)00661-3
20

Nsib, F., Ayed, N., and Chevalier, Y., Selection of dispersants for the dispersion of carbon black in organic medium, Progress in Organic Coatings 55(4):303-310 (2006).

10.1016/j.porgcoat.2005.11.006
21

Ridaoui, H., Jada, A., Vidal, L., and Donnet, J. B., Effect of cationic surfactant and block copolymer on carbon black particle surface charge and size, Colloids and Surfaces A: Physicochemicla and Engineering Aspects 278(1-3):149-159 (2006).

10.1016/j.colsurfa.2005.12.013
22

Li, D. and Sun, G., Coloration of textiles with self-dispersible carbon black nanoparticles, Dyes and Pigments 72(2):144-149 (2007).

10.1016/j.dyepig.2005.08.011
23

Ghasemi-Kahrizsnagi, A., Neshati, J., Shariatpanahi, H., and Akabaribezhad, E., Improving the uv degradation resistance of epoxy coatings using modifies carbon black nanoparticles, Progress in Organic Coatings 85:199-207 (2015).

10.1016/j.porgcoat.2015.04.011
24

Liu, M. and Horrocks, A. R., Effect of carbon black on UV stability of LLDPE films under artificial wearhering conditions, Polymer Degradation and Stability 75(3):485-499 (2002).

10.1016/S0141-3910(01)00252-X
25

Horrocks, A. R., Mwila, J., Miraftab, M., Liu, M., and Chohan, S. S., The influence of carbon black on properties of orientated polypropylene 2. Thermal and photodegradation, Polymer Degradation and Stability 65(1):25-36 (1999).

10.1016/S0141-3910(98)00213-4
26

Pfaff, G., Carbon black pigments, Journal of Physical Science Reviews 7(2):109-125 (2021).

10.1515/psr-2020-0152
27

Lee, J. Y., Jo, H. M., Lee, Y. H., and Sung, Y. J., Effect of pulp on the strength of coloring paper used for the production of fruit bags, Journal of Korea TAPPI 53(4):124-131 (2021).

10.7584/JKTAPPI.2021.08.53.4.124
28

Xiao, Z., Renaud, S., and Paice, M., Cellulase deinking of fresh and aged recycled newsprint/magazines (ONP/OMG), Enzime and microbial technology 43(2):103-106 (2008).

10.1016/j.enzmictec.2007.11.005
29

Zeb, H., Hussain, M. A., Ahmed, I., Akram, M. S., Haider, B., Haider, R., Babar, Z. B., Saleem, R. M., Ahsan, A., Aziz, I., and Arif, M., Study of bleaching of old newsprint recycled paper: reproduction of newspaper material, Material Research Express 8(8):1-11 (2021).

10.1088/2053-1591/ac1ca9
30

Hartley, P. A. and Parfitt, G. D., Dispersion of powders in liquids, 1. The contribution of the van der waals force to the cohesiveness of carbon black powders, Langmuir 1:651-657 (1985).

10.1021/la00066a003
31

Chauhan, V. S. and Bhardwaj, N. K., Effect of particle size of talc filler on structural and optical properties of paper, Lignocellulose 1(3):241-259 (2012).

32

Hubbe, M. A. and Gill, R. A., Fillers for papermaking: A review of their properties, usage practices, and their mechanistic role, BioResources 11(1):2886-2963 (2016).

10.15376/biores.11.1.2886-2963
33

Kang, H., Won, J. M., and Cho, B. U., Effects of production variables of fines-pcc composite fillers on paper properties (I) : Stirring time and dosage of flocculants, Journal of Korea TAPPI 51(6):135-143 (2019).

10.7584/JKTAPPI.2019.12.51.6.135
34

Lee, K. H. and Lee, H. L., Preflocculation of GCC with Cationic PAM and cationic starch and the influence of their dosage and shear rate on profloc size, Journal of Korea TAPPI 38(4):1-9 (2006).

Information
  • Publisher :Korea Technical Association of The Pulp and Paper Industry
  • Publisher(Ko) :한국펄프종이공학회
  • Journal Title :Journal of Korea TAPPI
  • Journal Title(Ko) :펄프종이기술
  • Volume : 56
  • No :5
  • Pages :49-57
  • Received Date : 2024-09-12
  • Revised Date : 2024-10-10
  • Accepted Date : 2024-10-10
  • DOI :https://doi.org/10.7584/JKTAPPI.2024.10.56.5.49
Journal Informaiton Journal of Korea TAPPI Journal of Korea TAPPI
Online Submission
  • scopus
  • NRF
  • KOFST
  • crossref crossmark
  • crossref cited-by
  • crosscheck
  • orcid
Journal Informaiton Journal Informaiton - close