All Issue

2016 Vol.48, Issue 5 Preview Page
Effects of Fly Ash Blended Surface Sizing on Physical Properties of Paper

Fly Ash를 이용한 표면사이징이 종이의 물리적 특성에 미치는 영향

Jin Ho Seo
,
Tai Ju Lee
,
Dong Jin Lee1
,
Jeong Yong Ryu1†
서진호
,
이태주
,
이동진 1
,
류정용 1†
Changgang Institute of Paper Science & Technology, Kangwon National University, Kangwondaehak-gil 1, Chuncheon-si, Gangwon-do
1Dept. of Paper Science & Engineering, College of Forest and Environmental Sciences, Kangwon National University, Chunchon
강원대학교 창강제지기술연구소
1강원대학교 산림환경과학대학 제지공학과
†E-mail: jyryu@kangwon.ac.kr
30 October 2016. pp. 61-67
PDF XML Citation
Abstract

Fly ash is usually used to improve the durability of concrete is composed of magnesium, calcium and unburned carbon. In this study, fly ash from cogeneration plant was analyzed and mixed in starch surface size in order to improve the physical properties of paper.

Main components of fly ash are silicon and aluminum. Its chemical structure are mullite and quartz based on silicon dioxide and aluminosilicate. In surface sizing, formation of uniform layer improves physical properties of paper as the vulnerable part of paper could be reinforced. As dosage of fly ash increases, sizing solution is uniformly built up in the surface of paper and surface sizing with fly ash has better performance in burst strength than common surface sizing based on starch. Therefore, it is assumed that fly ash is available as a pigment in surface sizing to improve the coverage of starch film on paper.

Keywords
Fly ash
size press
physical properties
surface sizing
References

References

1
J. H. Seo, D. C. Choi, J. Y. Ryu and S. H. Chung, Journal of Korea TAPPI, Effect of fatty acid and non-ionic surfactant on the deinkability of mixed recovered paper, 47(2); 34-41 (2015)

Seo, J. H., Choi, D. C., Ryu, J. Y., and Chung, S. H., Effect of fatty acid and non-ionic surfactant on the deinkability of mixed recovered paper, Journal of Korea TAPPI 47(2):34-41 (2015).

2
J. E. Kim, J. Y. Ryu, J. H. Shin and S. K. Ow, Journal of Korea TAPPI, Recycling of wastepapers (Ⅰ) - Improvement of drainage and strength properties of testliner through the blended enzyme treatment, 30(3); 22-28 (1998)

Kim, J. E., Ryu, J. Y., Shin, J. H., and Ow, S. K., Recycling of wastepapers (Ⅰ) - Improvement of drainage and strength properties of testliner through the blended enzyme treatment, Journal of Korea TAPPI 30(3):22-28 (1998).

3
K. R. Ji, J. Y. Ryu, J. H. Shin, B. K. Song and S. K. Ow, Journal of Korea TAPPI, Recycling of wastepaper (Ⅲ) - Improvement of drainage and strength properties of testliner by successive treatments of flotation and mixed enzyme, 31(1); 10-16 (1999)

Ji, K. R., Ryu, J. Y., Shin, J. H., Song, B. K., and Ow, S. K., Recycling of wastepaper (Ⅲ) - Improvement of drainage and strength properties of testliner by successive treatments of flotation and mixed enzyme, Journal of Korea TAPPI 31(1):10-16 (1999).

4
H. J. Kim, J. M. Won and B.-U. Cho, Journal of Korea TAPPI, Strength improvement of linerboard by impregnation with PVAm, 44(1); 58-64 (2012)

Kim, H. J., Won, J. M., and Cho, B.-U., Strength improvement of linerboard by impregnation with PVAm, Journal of Korea TAPPI 44(1):58-64 (2012).

5
D. J. Son and B. Y. Kim, Journal of Korea TAPPI, Study of paper strengthening properties with polyvinylamine, 37(4); 26-31 (2005)

Son, D. J. and Kim, B. Y., Study of paper strengthening properties with polyvinylamine, Journal of Korea TAPPI 37(4):26-31 (2005).

6
K. M. Han, H. Kang, J. K. Kim and B. U. Cho, Strength improvement of linerboards by surface application of kraft black liquorIn Proceeding of Spring Conference of the Korea TAPPI; 30 (2013)

Han, K. M., Kang, H., Kim, J. K., and Cho, B. U., Strength improvement of linerboards by surface application of kraft black liquor, In Proceeding of Spring Conference of the Korea TAPPI, p. 30 (2013).

7
J. Y. Lee, C. H. Kim, J. H. Park, E. H. Kim and K. T. Yun, Journal of Korea TAPPI, Development of new organic filler for improving paperboard strengths, 47(5); 74-79 (2015)

Lee, J. Y., Kim, C. H., Park, J. H., Kim, E. H., and Yun, K. T., Development of new organic filler for improving paperboard strengths, Journal of Korea TAPPI 47(5):74-79 (2015).

8
Y. B. Jeong, H. L. Lee, H. J. Youn, K. H. Jeong and H. Ryu, Journal of Korea TAPPI, Influence of the viscosity of surface sizing starch solutions on surface sizing effect of linerboard, 44(5); 54-62 (2012)

Jeong, Y. B., Lee, H. L., Youn, H. J., Jeong, K. H., and Ryu, H., Influence of the viscosity of surface sizing starch solutions on surface sizing effect of linerboard, Journal of Korea TAPPI 44(5):54-62 (2012).

9
Y. B. Jeong, H. L. Lee and H. J. Yoon, A study on the surface properties of surface sized papers with starch and inorganic pigmentIn Proceeding of Spring Conference of the Korea TAPPI; 85 (2016)

Jeong, Y. B., Lee, H. L., and Yoon, H. J., A study on the surface properties of surface sized papers with starch and inorganic pigment, In Proceeding of Spring Conference of the Korea TAPPI, p.85 (2016).

10
S. I. Jeon, J. H. Nam, J. B. Lee and S. A. Kwon, Journal of the Korean Society of Civil Engineers, Development of rapid-setting concrete using ultra-fine fly ash, 57(2); 19-23 (2009)

Jeon, S. I., Nam, J. H., Lee, J. B., and Kwon, S. A., Development of rapid-setting concrete using ultra-fine fly ash, Journal of the Korean Society of Civil Engineers 57(2):19-23 (2009).

11
B. S. Mohammed, O. C. Fang, K. M. A. Hossain and M. Lachemi, Construction and Building Materials, Mix proportioning of concrete containing paper mill residuals using response surface methodology, 35; 63-68 (2012)

Mohammed, B. S., Fang, O. C., Hossain, K. M. A., and Lachemi, M., Mix proportioning of concrete containing paper mill residuals using response surface methodology, Construction and Building Materials 35:63-68 (2012).

12
C. W. Park, J. S. Sim, T. S. Kang and S. E. Park, Journal of the Korean Society of Civil Engineers, Environmental assessment of shotcrete using recycled industrial by-products (fly ash) and silica fume, 30(3C); 159-165 (2010)

Park, C. W., Sim, J. S., Kang, T. S., and Park, S. E., Environmental assessment of shotcrete using recycled industrial by-products (fly ash) and silica fume, Journal of the Korean Society of Civil Engineers 30(3C):159-165 (2010).

13
A. S. Ribeiro, R. C. Monteiro, E. J. Davim and M. H. V. Fernandes, Journal of hazardous materials, Ash from a pulp mill boiler - Characterisation and vitrification, 179(1); 303-308 (2010)

Ribeiro, A. S., Monteiro, R. C., Davim, E. J., and Fernandes, M. H. V., Ash from a pulp mill boiler - Characterisation and vitrification, Journal of hazardous materials 179(1):303-308 (2010).

14
M. Bird and J. Talberth, Waste stream reduction and reuse in the pulp and paper sectorIndustrial Footprint Project, Center for Sustainable Economy, Washington State Department of Ecology, Olympia, WA, USA (2008)

Bird, M. and Talberth J., Waste stream reduction and reuse in the pulp and paper sector, Industrial Footprint Project, Center for Sustainable Economy, Washington State Department of Ecology, Olympia, WA, USA (2008).

15
V. C. Srivastava, I. D. Mall and I. M. Mishra, Colloids and Surfaces A, Treatment of pulp and paper mill wastewaters with poly aluminium chloride and bagasse fly ash, 260(1); 17-28 (2005)

Srivastava, V. C., Mall, I. D., and Mishra, I. M., Treatment of pulp and paper mill wastewaters with poly aluminium chloride and bagasse fly ash, Colloids and Surfaces A 260(1):17-28 (2005).

16
Y. J. Sung, W. G. Jung and J. Y. Lee, Journal of Korea TAPPI, Change in the functional properties of mulching paper by the addition of inorganic materials, 6(45); 64-71 (2013)

Sung, Y. J., Jung, W. G., and Lee, J. Y., Change in the functional properties of mulching paper by the addition of inorganic materials, Journal of Korea TAPPI (45)6:64-71 (2013).

17
S. S. Lee, Mechanical properties of non-cement matrix according to replacement ratio of fly ash in the thermoelectric power plant with combined heat and power plant, Korea. Hanbat National University. (2014)

Lee, S. S., Mechanical properties of non-cement matrix according to replacement ratio of fly ash in the thermoelectric power plant with combined heat and power plant, Master Thesis, Hanbat National University, Korea (2014).

18
J. L. Alonso, K. Wesche and (ed.) K. Wesche, Fly Ash in Concrete: Properties and Performance; 3-23, USA. E & FN SPON, Cleveland. (2005)

Alonso, J. L. and Wesche, K., Fly Ash in Concrete: Properties and Performance, Wesche, K. (ed.), E & FN SPON, Cleveland, USA, pp. 3-23 (2005).

19
G. Y. Jeong, S. H. Kim and K. J. Kim, Journal of the Mineralogical Society of Korea, Rare metal chemistry, microstructures, and mineralogy of coal ash from thermal power plant of Korea, 28(2); 147-163 (2015)

Jeong, G. Y., Kim, S. H., and Kim, K. J., Rare metal chemistry, microstructures, and mineralogy of coal ash from thermal power plant of Korea, Journal of the Mineralogical Society of Korea 28(2):147-163 (2015).

20
P. Sultana, S. Das, A. Bhattacharya, R. Basu and P. Nandy, Rev. Adv. Mater. Sci, Mullite formation in coal fly ash is facilitated by the incorporation of magnesium oxide, 27; 69-74 (2011)

Sultana, P., Das, S., Bhattacharya, A., Basu, R., and Nandy, P., Mullite formation in coal fly ash is facilitated by the incorporation of magnesium oxide, Rev. Adv. Mater. Sci. 27:69-74 (2011).

21
ACI Committee 232, Research reports on “Use of Fly Ash in Concrete”, Detroit, USA. (1996)

ACI Committee 232, Research reports on “Use of Fly Ash in Concrete”, Detroit, USA (1996).

22
Y. B. Jeong, Fluid and film properties of surface sizing agent with inorganic pigments, Korea. Seoul National University. (2016)

Jeong, Y. B., Fluid and film properties of surface sizing agent with inorganic pigments, Doctorial Thesis, Seoul National University, Korea (2016).

23
R. N. Jopson, Paper360°, Size press and sheet penetration, July/August; 24-25 (2010)

Jopson, R. N., Size press and sheet penetration, Paper360° July/August:24-25 (2010).

24
Y. B. Jeong, H. L. Lee, H. J. Youn, K. H. Jung, K. R. Ji and Y. S. Kim, Journal of Korea TAPPI, Reduction of drying energy for after dryers using oxidized starch ester, 45(4); 9-15 (2013)

Jeong, Y. B., Lee, H. L., Youn, H. J., Jung, K. H., Ji, K. R., and Kim, Y. S., Reduction of drying energy for after dryers using oxidized starch ester, Journal of Korea TAPPI 45(4):9-15 (2013).

25
S. P. Singh, Indian Journal of Chemical Technology, Relationship of z-tensile strength with in-plane strength properties of paper, 14(3); 317-320 (2007)

Singh, S. P., Relationship of z-tensile strength with in-plane strength properties of paper, Indian Journal of Chemical Technology 14(3):317-320 (2007).

Information
  • Publisher :Korea Technical Association of The Pulp and Paper Industry
  • Publisher(Ko) :한국펄프종이공학회
  • Journal Title :Journal of Korea TAPPI
  • Journal Title(Ko) :펄프종이기술
  • Volume : 48
  • No :5
  • Pages :61-67
  • Received Date : 2016-09-20
  • Revised Date : 2016-10-18
  • Accepted Date : 2016-10-21
  • DOI :https://doi.org/10.7584/jktappi.2016.10.48.5.61
Journal Informaiton Journal of Korea TAPPI Journal of Korea TAPPI
Online Submission
  • scopus
  • NRF
  • KOFST
  • crossref crossmark
  • crossref cited-by
  • crosscheck
  • orcid
Journal Informaiton Journal Informaiton - close