Evaluation of Applicability of PCC as a Paper-making Filler Produced by CCU System Technology

Hyeonggyu Lee; Heeseop Kim; Hyoung Jin Kim

doi:10.7584/JKTAPPI.2018.10.50.5.161

All Issue

2018 Vol.50, Issue 5 Preview Page Next Page

Evaluation of Applicability of PCC as a Paper-making Filler Produced by CCU System Technology CCU 시스템 기술을 이용해 합성한 PCC의 제지용 충전제 적용성 평가

30 October 2018. pp. 161-170

PDF XML

Abstract

This study is intended to reduce the CO₂ emitted from plants, and the emitted CO₂ is known to influence on the global warming. Though the cement industry is one of the areas which generate a high amount of CO₂ emissions, the emitted CO₂ has an advantage of being used for CCU technology due to its low content of sulfur compounds. Accordingly, in this study, a CCU pilot plant has been installed in a domestic cement company to capture the CO₂ emitted from the Kilns and to condense it to use for PPC synthesis.

This study is attempted to evaluate a feasibility of using the synthesized PPC from the CCU process system as fillers for papers. To this end, the morphology, sizes and distributions of the synthesized PCC from the cement company have been analyzed. Two types of the synthesized PCC from the CCU process system were compared with commercial fillers for papers. A feasibility of producing PCC from the CCU process as paper fillers has been confirmed. In case of type #1, paper formation was lower than the commercial fillers, but bulk and tensile strength were superior. In case of the type #2, it showed superior scattering coefficient and opacity. The XRF results indicate that of the CaO used for PCC synthesis contained not only CaO, but metal ions in oxide status. The presence of such metal ions in CaO was identified responsible for hindering the crystallization of PCC and lowering the brightness.

Keywords

Precipitated calcium carbonate (PCC)

filler

carbon capture and utilization (CCU)

carbon dioxide emission

References

Literature Cited

Paris Agreement by UNFCCC, (https://unfccc.int/resource/docs/2015/cop21/eng/l09r01.pdf)

Paris Agreement by UNFCCC (https://unfccc.int/resource/docs/2015/cop21/eng/l09r01.pdf).

COP 21, Paris agreement short glossary, (http://www.cop21.gouv.fr/en/les-mots-de-laccord)

COP 21, Paris agreement short glossary (http://www.cop21.gouv.fr/en/les-mots-de-laccord).

Y. I. Yoon, Y. E. Kim, S. C. Nam, S. Y. Park, I. S. Chun, S. D. Lee and H. S. Kim, Energy Procedia, Economic analysis of CCU in the Korea cement industry : CO₂ capture using KIERSOL & PCC conversion, 114; 6240-6245 (2017)

Yoon, Y. I., Kim, Y. E., Nam, S. C., Park, S. Y., Chun, I. S., Lee, S. D., and Kim, H. S., Economic analysis of CCU in the Korea cement industry : CO₂ capture using KIERSOL & PCC conversion, Energy Procedia 114:6240-6245 (2017).

10.1016/j.egypro.2017.03.1762

B. Jones, Sedimentary Geology, Review of calcium carbonate polymorph precipitation in spring system, 353; 64-75 (2017)

Jones, B., Review of calcium carbonate polymorph precipitation in spring system, Sedimentary Geology 353:64-75 (2017).

10.1016/j.sedgeo.2017.03.006

B. Feng, A. K. Yong and Hui. An, Material Science and Engineering A, Effect of various factors on the particle size of calcium carbonate formed in a precipitation process, 445-446; 170-179 (2007)

Feng, B., Yong, A. K., and An, Hui., Effect of various factors on the particle size of calcium carbonate formed in a precipitation process, Material Science and Engineering A 445-446:170-179 (2007).

Global Industry Analysts, “Calcium Carbonate Market Trends”, (http://www.strategyr.com/MarketResearch/Calcium_Carbonate_Market_Trends.asp) (2015)

Global Industry Analysts, 2015, “Calcium Carbonate Market Trends” (http://www.strategyr.com/MarketResearch/Calcium_Carbonate_Market_Trends.asp).

B. Krogerus and L. Neimo, Book 4. Papermaking Chemistry. Papermaking Science and Technology; 126-128, Helsinki, Finland. Fapet Oy TAPPI Press. (2000)

Krogerus, B., Papermaking Science and Technology, Book 4. Papermaking Chemistry, Neimo, L., Fapet Oy TAPPI Press, Helsinki, Finland, pp. 126-128 (2000).

T. Enomae and K. Tsujiono, TAPPI Journal, Application of spherical hollow calcium carbonate paricles as filler and coating pigment, 3(6); 2 (2004)

Enomae, T., and Tsujiono, K., Application of spherical hollow calcium carbonate paricles as filler and coating pigment, TAPPI Journal, 3(6):2 (2004).

T. J. Lee, Crystallization of precipitated calcium carbonate by anionic PAM-added carbonation for papermaking, Kookmin University. (2013)

Lee, T. J., Crystallization of precipitated calcium carbonate by anionic PAM-added carbonation for papermaking, PhD Thesis, Kookmin University (2013).

H. L. Lee, T. Y. Kim and H. J. Youn, Journal of Korea TAPPI, Retention and drainage characteristics of compozil system and impact of cationic corn starch for its improvement, 30(2); 30-39 (1998)

Lee, H. L., Kim, T. Y., and Youn, H. J., Retention and drainage characteristics of compozil system and impact of cationic corn starch for its improvement, Journal of Korea TAPPI 30(2):30-39 (1998).

C. Domingo, E. Loste, J. Gómez-Morales, J. García-Carmina and J. Fraile, J. Supercritical Fluids, Calcite precipitation by high-pressure CO₂ carbonation route, 36; 202-215 (2006)

Domingo, C., Loste, E., Gómez-Morales. J., García-Carmina. J., and Fraile. J., Calcite precipitation by high-pressure CO₂ carbonation route, J. Supercritical Fluids 36:202-215 (2006).

10.1016/j.supflu.2005.06.006

M. J. Park, J. W. Ahn and H. Kim, Journal of the Korean Ceramic Society, Study on the dispersion stability of precipitated calcium carbonate suspensions, 38(4); 343-350 (2001)

Park, M. J., Ahn, J. W., and Kim, H., Study on the dispersion stability of precipitated calcium carbonate suspensions, Journal of the Korean Ceramic Society, 38(4):343-350 (2001).

M. Kitamura, Journal of Crystal Growth, Controlling factor of polymorphism in crystallization process, 237-239; 2205-2214 (2002)

Kitamura, M., Controlling factor of polymorphism in crystallization process, Journal of Crystal Growth 237-239:2205-2214 (2002).

H. L. Lee, B. J. Lee, D. S. Shin, Y. B. Seo, K. P. Im, J. M. Won and C. M. Son, Papermaking Science; 281-293, Gwangil munhwasa. (1995)

Lee, H. L., Lee, B. J., Shin, D. S., Seo, Y. B., Im, K. P., Won, J. M., and Son, C. M., Papermaking Science, pp. 281-293, Gwangil munhwasa (1995).

Y. B. Seo, J. S. Choi and S. G. Ji, Korea Chem. Eng. Res, Stability of pre-treated fillers for high loaded printing paper, 55(1); 1-6 (2017)

Seo, Y. B., Choi, J. S., and Ji, S. G., Stability of pre-treated fillers for high loaded printing paper, Korea Chem. Eng. Res., 55(1):1-6 (2017).

Information

Publisher :Korea Technical Association of The Pulp and Paper Industry
Publisher(Ko) :한국펄프종이공학회
Journal Title :Journal of Korea TAPPI
Journal Title(Ko) :펄프종이기술
Volume : 50
No :5
Pages :161-170
Received Date : 2018-10-10
Revised Date : 2018-10-23
Accepted Date : 2018-10-24
DOI :https://doi.org/10.7584/JKTAPPI.2018.10.50.5.161

Journal of Korea TAPPI ISSN:0253-3200(Print) 펄프종이기술

All Issue

Literature Cited